Mounted right the first time
A mounted TV looks simple, and that is the point. What makes it simple to look at is the work behind it: finding the studs, choosing the right fasteners, setting the height for where you actually sit, and getting it level to the degree. We mount flat, tilting, and full-motion mounts on drywall, plaster, brick, and stone.
Every mount goes into framing or masonry. Hollow-wall anchors alone are not the right way to hang a large TV, and a full-motion arm puts a lot of leverage on the wall when it is pulled out. We use fasteners rated for the mount and the load, and we test the mount before the TV goes on it.
Choosing the height and the mount
The most common mistake is mounting too high. For a living room, the middle of the screen should sit close to eye level from the sofa. Above a fireplace, that is rarely possible, which is where a tilting mount or a pull-down mount earns its place. We will talk through the room with you before a single hole is drilled, and mark the position so you can see it first.
We can source and purchase a mount for you, or install one you’ve already purchased. Tell us your TV model when you book. We check that the mount is rated for your TV’s size and weight before we use it.
Hiding the cables
Cables hanging below a mounted TV undo most of the effect. There are two clean ways to deal with them. The tidiest is an in-wall kit designed and rated for the purpose, which runs power and signal cables inside the wall between two plates. The other is a paintable raceway on the surface, which suits brick, stone, and walls where running cables inside is not practical.
What we do not do is run a standard extension cord inside a wall, which is not safe or allowed, or add new electrical circuits. If you want a new outlet in a new location, we’ll recommend a licensed electrician we’ve vetted for that work.
Soundbars, shelves, and the old mount
We mount soundbars under the TV, and small shelves or brackets for streaming boxes and consoles. If you are replacing a TV, we take down the old mount and patch and touch up the holes it leaves. That kind of patching is part of our drywall repair work. Moving in or rearranging a room? Mounting a TV pairs well with furniture assembly and installation on the same visit.
What to have ready on the day
Have the TV out of its box if you can, with the remote, the power cable and any stand screws, and the mount with all of its hardware. Know which devices you want connected, such as a streaming box, a gaming console, or a soundbar, so every cable is run in one go. Clear the furniture from in front of the wall, or leave it to us if it is too heavy to move. When we leave, the TV will be on, level and connected, and the dust from drilling cleaned up.